# Tandberg Data RDX QuikStation Network Configuration File:
#
# Use this file to manually configure the RDX QuikStation IP address to a static 
# IPv4 address via a USB flash drive.  NOTE: If automatic IP address assignment 
# via DHCP is desired, no action is necessary as DHCP is the factory default setting.  
#
# Upon startup, the QuikStation will display the current IP settings and address 
# across all LCD's.  However, following initial setup and configuration, Tandberg 
# Data recommends that you assign a static IP address to the RDX QuikStation to 
# prevent inadvertent IP address changes of the iSCSI target.
#
# Follow the steps below to configure a static IPv4 address: 
#
# Step 1: Obtain an available IP address and subnet mask for the RDX QuikStation. 
# Edit the following configuration statements to meet your network's requirements.
# Since any line that begins with '#' is ignored by the RDX QuikStation, remove 
# the '#' from each modified line so the QuikStation can decipher the setting 
# changes.  Note that if you choose to specify a static IP address, both IP and 
# SUBNETMASK fields must be "uncloaked" (GATEWAY is optional).
#
# -- start edit section --
#
# IP=192.168.10.2
# SUBNETMASK=255.255.255.0
# GATEWAY=192.168.10.1
#
# -- end edit section --
#
# Step 2: Save this newly-edited file to the root directory of the USB memory 
# stick included with the RDX QuikStation.  If the included USB stick is unavailable, 
# any USB memory stick with a VFAT file system will suffice.  IMPORTANT: The name 
# of this file must remain network.conf for the RDX QuikStation to recognize and 
# process it.	
#
# Step 3: Insert the USB stick into the USB port located in the center of the
# front panel of the RDX QuikStation. The USB symbol on the center-front LED panel 
# will flash and the LCD's will broadcast the message "NetUpdate".  When the update 
# process is complete, the LCD's will flash the message "PASSED" and the USB symbol 
# will stop flashing and illuminate solid indicating that it is safe to remove the 
# USB stick.  Remove the USB stick.
#
# Step 4: To access the RDX QuikStation's web-based management console, enter your 
# newly-established IP address as the URL in a web browser using the following format: 
#
# <http://<RDX QuikStation IP address>
#
# After accessing the RDX QuikStation's web-based management console, you can verify 
# the IP Address configuration, and also configure optional DNS server addressing 
# information. 
#
# For further information, please refer the RDX QuikStation Quick Start Guide and/or 
# Product Manual.