Using Tandberg Autoloader with Adaptec ASC-1045 HBA with Linux
Jump to navigation
Jump to search
Please note that this article / this category refers either on older software / hardware components or is no longer maintained for other reasons. This page is no longer updated and is purely for reference purposes still here in the archive available. |
---|
The Adaptec SAS HBA ASC-1045 is supported by Linux core until 2.6.33.
The corresponding core can be found here:
http://kernel.ubuntu.com/~kernel-ppa/mainline/v2.6.33/
On Ubuntu, the core can be installed using the command:
dpkg -i <paketnamen>
The HBA and the loader will be immediately recognized. Then the card and the tape device will be detected.
Related articles
Firmware Update of LSI 9xxx HBAs on H8 / X9-motherboards
LSI 6Gb/s SATA+SAS PCIe 3.0 HBAs
LSI HBA Firmware Downgrade